Central Heating Repair in Co. Sligo

A heating system that has stopped heating properly rarely announces which part failed, and the pattern of what is cold says more than the boiler does. Radiators cold at the top and warm at the bottom just need bleeding, because air collects at the highest point. Cold at the bottom is the opposite complaint: something has settled where water should be moving. One cold room while the rest of the house is fine points at that radiator, its valves or the balancing of the system. Everything cold at once points instead at the boiler, the pump, a zone valve or the controls, and those are four very different repairs.

Most of what shortens the life of an Irish heating system sits in the pipework rather than in the boiler. Water standing in steel radiators produces magnetite, a black iron oxide sludge that drops to the bottom of radiators, chokes narrow heat exchanger passages and wears out pump bearings. A power flush or a chemical clean shifts it. A magnetic filter on the return catches what forms afterwards and an inhibitor slows the reaction down, which is why an engineer who cleans a system and fits nothing to keep it clean has done half a job.

Where the work stops being plumbing matters. Anything on the gas side of a natural gas or LPG boiler must be done by an installer on the Register of Gas Installers of Ireland, and putting heating controls on a new circuit is restricted electrical work requiring a Safe Electric registered contractor. Radiators, valves, pumps and pipework carry no such restriction. Cost follows how many radiators are involved, whether the system is being cleaned or partly replaced, how buried the pipework is, and whether zoning is added.